Текст страницы
Appendix
Health and safety information
Exposure to Radio Frequency (RF) Signals Certification Information
This product can contain an embedded radio transmitter and receiver. It is designed
and manufactured not to exceed the exposure limits for radio frequency (RF) energy set
by the Federal Communications Commission (FCC) of the U.S. government. These FCC
exposure limits are derived from the recommendations of two expert organizations, the
National Council on Radiation Protection and Measurement (NCRP) and the Institute of
Electrical and Electronics Engineers (IEEE). In both cases, the recommendations were
developed by scientific and engineering experts drawn from industry, government, and
academia after extensive reviews of the scientific literature related to the biological
effects of RF energy.
Before a new model is available for sale to the public, it must be certified to the FCC that
it does not exceed the exposure limit established by the FCC. Evaluation per each model
is performed in positions and locations (such as at the bottom on the body) as required
by the FCC.
For body worn operation, this model meets the FCC RF exposure guidelines when used
with Samsung accessory designated for this product. Non-compliance with the above
restrictions may result in violation of FCC RF exposure guidelines.
RF exposure or SAR information can be viewed on-line at www.fcc.gov/oet/ea/fccid/.
This site uses this product FCC ID number on the outside of the product. Sometimes it
may be necessary to remove the battery pack to find number. Once you have the FCC
ID number for a particular product, follow the instructions on the website and it should
provide RF exposure information or values for typical or maximum SAR for particular
product.
For corresponding model only
The Specific Absorption Rate (SAR) is a measure of the rate of absorption of RF energy
by the human body expressed in units of watts per kilogram (W/kg). The FCC wireless
devices to comply with a safety limit of 1.6 watts per kilogram (1.6 W/kg).
SAR level of this device while operating can be well below the maximum value. This is
because the device is designed to operate at multiple power levels so as to use only the
power required to reach the network. In general, the closer you are to a wireless base
station antenna, the lower the power output.