Текст страницы
Spillovers on the
touch controls
Technical Specification
Cooking Hob
CEH6DXECTT/1RU
Cooking Zones
4 Zones
Supply Voltage
220-240V~, 50-60Hz
• The cooktop may beep and turn
itself off, and the touch controls
may not function while there is
liquid on them. Make sure you
wipe the touch control area dry
before turning the cooktop back
on.
Installed Electric Power
6039-7186W
1. Switch the power to the
cooktop off.
2. Soak up the spill
3. Wipe the touch control area
with a clean damp sponge or
cloth.
4. Wipe the area completely
dry with a paper towel.
5. Switch the power to the
cooktop back on.
Product Size
L×W×H(mm)
590X520X52
Built-in Dimensions A×B (mm)
560X490
Weight and Dimensions are approximate. Because we continually strive to
Hints and Tips
improve our products we may change specifications and designs without prior
Problem
Possible causes
What to do
notice.
The cooktop cannot
Be turned on.
No power.
Installation
Selection of installation equipment
The controls are locked.
Make sure the cooktop is connected
to the power supply and that it is
switched on.
Check whether there is a power
outage in your home or area. If
you’ve checked everything and the
problem persists, call a qualified
technician.
The touch controls are
unresponsive.
Unlock the controls. See section
‘Using your ceramic cooktop’ for
instructions.
The touch controls are
difficult to operate.
Make sure the touch control area is
dry and use the ball of your finger
when touching the controls.
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select
heat-resistant work surface material to avoid larger deformation caused by
the heat radiation from the hotplate. As shown below:
There may be a slight film of
water over the controls or you
may be using the tip of your
finger when touching the
controls.
The glass is being
scratched.
Rough-edged cookware.
Unsuitable, abrasive scourer or
cleaning products being used.
This is normal for cookware and
does not indicate a fault.
Use cookware with flat and smooth
bases. See ‘Choosing the right
cookware’.
See ‘Care and cleaning’.
Some pans make
crackling or clicking
noises.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
L(mm)
W(mm)
H(mm)
D(mm)
A(mm)
B(mm)
X(mm)
590
520
52
48
560+5
490+5
50 mini
Under any circumstances, make sure the ceramic cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the ceramic cooker hob is in
good work state. As shown below
EN-15
EN-16