Текст страницы
Wall mounting
• For installation methods and precautions, please refer to the installation guide of the wall mount you purchased.
• The wall mount must be purchased separately.
• Tip: This product is compatible with wall mounts that have a hole spacing of 75 × 75 mm.
• The bolts used to secure the wall mount must meet the following requirements: Quantity: 4; Thread: M4; Length: 10 mm.
• Lay the monitor flat, with its back facing upwards. Use your finger to press the spring clip that joins the base to the monitor and remove the base.
• Note: When removing the base, be careful not to pinch your finger in the spring clip.
• Follow the wall mount user manual and install the wall mount onto the bolts that are built into the housing back.
Secure the wall
mount as shown
in the picture.
Troubleshooting
Possible Cause
Solutions
Issue
Make sure the power adapter is plugged in properly.
Unable to turn on.
No power.
Adjust the brightness and contrast.
Image is dark.
Brightness/Contrast not
adjusted properly.
Image is jitery or has ripples.
Interference.
Keep the monitor away from electronic devices that
may cause electrical interference.
No image on the screen.
No signal, entering sleep mode.
Turn on the computer.
Make sure the computer’s graphics card is working properly.
Make sure the cable is plugged in properly.
Resolution is incorrect.
Use the specified recommended resolution setings.
The monitor displays that the
current resolution is not supported.
System to correct the image.
VGA input with screen out of center.
Please select VGA automatic adjustment in the
system to correct the image.