Текст страницы
27.01.2026, 14:59
K1 Manuals | Creality Wiki
1. Take the touch screen out of the toolbox and connect the touch screen to the flat cable
extended from the base according to Figure A. Then snap the touch screen into the slot
in the baseplate, as shown in Figure B. (The direction is as shown in the figure; otherwise,
the screen interface may be damaged.)
2. A:C onnection and power on.
B:Install the material barrel.
3. Load filaments. (Insert the filaments into the deepest part of the Teflon tube until it
cannot be moved.)
https://wiki.creality.com/en/k1-flagship-series/k1/quick-start-guide/user-manual
6/16