Текст страницы
Operating mode selection
mode. To disable this function, hold the
«Settings» button for 3 seconds.
Attention!
During heating, water may start to drip
from the opening of the safety valve.
Water leakage cannot be avoided and
must not be prevented, since blocking the
valve can lead to rupture of the internal
tank (in the event of an equipment failure).
Shutdown
Press the «Mode» button to select one
of the three operating modes of the
device: normal mode, «OptimalTEMP»,
«Turbo». When the «OptimalTEMP» and
«Turbo» indicators are off, this is the
normal operation mode, you can adjust
the temperature and select the power
mode. Pressing the «Mode» button again
will turn on the «OptimalTEMP» mode,
in which a fixed temperature of 55 ° C is
set and the average power mode. Press
«Mode» again to select «Turbo» mode.
This mode has a fixed temperature of
75 °C and an intensive power mode. In
the «OptimalTEMP» and «Turbo» modes,
the temperature and power adjustment
buttons do not work.
Indicators:
To turn off the water heater, press the «On/
Off» button. The water heater will stop
working, the screen will display the time and
the internal temperature of the water.
It is recommended to always disconnect the
water heater from the mains if you do not
plan to use the appliance for some time.
The water heater automatically maintains the
set temperature.
«Heat» - the indicator lights up when the
water in the tank is being heated.
«Warm» - the indicator lights up during heat
saving, when there is no heating.
Setting the time and timer
1. With the water heater off, press the
«Mode» button to set the time. The time
display “00” will flash on the screen. Set
the desired hour with button
or
.
Press the «Mode» button again to set the
minute time.
2. Press «Mode» again to set the timer to
turn on the water heater. At this time, the
indicator
will light up on the screen.
Set the desired hour with button
or
. Then press «Mode» again and enter the
minute time settings. After the setting
process is completed, the indicator
will turn off, the set time is automatically
saved.
3. To set the timer for heating when the
water heater is on, hold down the
“Settings” button for 3 seconds. In the
same way, using button
or
, set the
desired heating start time. The water
heater will work in heat saving mode and
heating will start when the set time is
reached. After heating is completed, the
appliance will return to the heat-saving
13