Текст страницы
SLEEP Function
Press SLEEP button
The SLEEP function is used to decrease energy while you sleep(and don’t
need the same temperature settings to stay comfortable). This function can
only by activated via remote control.
For the details, please see “sleep operation ” in “ USER’S MANUAL ”.
Note:
The SLEEP function is not available in FAN or DRY mode.
SET function
SET SET OK
or
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area, press the
OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
*
*
Fresh ( ) Follow Me( ) AP mode( )
[ ]: If your remote controller has Fresh button, you can not use the SET button to
select Fresh feature.
FRESH function( ) (some units) :
When the FRESH function is initiated, the Ionizer/Plasma Dust Collector(depending
on models) is energized and will help to remove pollen and impurities from the air
Follow me function( ) :
The FOLLOW ME function enables the remote control to measure the temperature at its current location
and send this signal to the air conditioner every 3 minutes interval. When using AUTO, COOL or HEAT
modes, measuring ambient temperature from the remote control(instead of from the indoor unit itself) will
enable the air conditioner to optimize the temperature around you and ensure maximum comfort.
NOTE: Press and hold Turbo button for seven seconds to start/stop memory feature of Follow Me function.
If the memory feature is activated, On displays for 3 seconds on the screen.
,
,
,
,
,
,
,
,
If the memory feature is stopped, OF displays for 3 seconds on the screen.
While the memory feature is activated, press the ON/OFF button, shift the mode or power failure
will not cancel the Follow me function.
AP function( )(some units) :
Choose AP mode to do wireless network configuration. For some units, it doesn’t work by pressing
the SET button. To enter the AP mode, continuously press the LED button seven times in 10 seconds.