Текст страницы
Getting Started
[SYSTEM]
Change the crossover type
[KEY BEEP]
(Applicable only if [X’OVER] is set to [2WAY].)
[ON]: Activates the keypress tone. ; [OFF]: Deactivates.
[TDF ALARM]
(Applicable only if [X’OVER] is set to [2WAY].)
[ON]: Activates the alarm if you forget to detach the faceplate when
ACC is set to OFF. ; [OFF]: Deactivates.
[SOURCE SELECT]
1 Press B SRC repeatedly to enter STANDBY.
2 Press and hold number buttons 4 and 5 to enter crossover select.
The current crossover type appears.
3 Turn the volume knob to select “2WAY” or “3WAY”, then press the
knob.
4 Turn the volume knob to select “YES” or “NO”, then press the knob.
The selected crossover type appears.
[BT AUDIO SRC]
[ON]: Enables BT AUDIO in source selection. ; [OFF]: Disables.
(Page 19)
• To cancel, press and hold
.
• To adjust the selected crossover settings, see page 21.
[BUILT-IN AUX]
[ON]: Enables AUX in source selection. ; [OFF]: Disables. (Page 12)
[F/W UPDATE]
[UPDATE SYSTEM]
Once you have changed the crossover type, the next time when you turn on
the power, the display shows:
“2-WAY X ’ OVER” or “3-WAY X ’ OVER” “PRESS” “VOLUME KNOB” “TO
CONFIRM”
Press the volume knob to acknowledge in order to proceed to the next
desired operation.
[F/W UP xxxx]
[YES]: Starts upgrading the firmware. ; [NO]: Cancels (upgrading is not
activated).
For details on how to update the firmware, visit
<https://www.kenwood.com/cs/ce/>.
• Once you have upgraded the firmware, you are unable to downgrade
the firmware.
CAUTION
Select a crossover type according to how the speakers are connected.
(Page 28, 29)
[FACTORY RESET]
[YES]: Resets the settings to default (except the stored station). ;
[NO]: Cancels.
[ENGLISH]
Select the display language for [FUNCTION] menu and music
information if applicable.
By default, [ENGLISH] is selected.
[TURKCE]
If you select a wrong type:
• The speakers may damage.
• The output sound level may be extremely high or low.
ENGLISH
7