Текст страницы
13. TROUBLESHOOTING
I
WARNING: Always stop unit and disconnect spark plug before performing all of the
recommended remedies below except remedies that require operation of the unit.
GB
When you have checked all the possible causes listed and you are still experiencing the problem, see
your Servicing Dealer. If you are experiencing a problem that is not listed in this chart, see your
Servicing Dealer for service.
F
PROBLEM
POSSIBLE CAUSE
SOLUTION
D
Engine will not start or will run
only a few seconds after starting.
1. No spark
E
2. Flooded engine.
1. Watch for spark at spark plug tip. If there
is no spark, repeat test with a new spark
plug (RCJ7Y).
2. Follow procedure page 30 If engine still
fails to start, repeat procedure with a
new spark plug.
NL
Carburetor requires adjustment.
Contact a Servicing Dealer for carburetor
adjustment.
GB
Engine starts but will not
accelerate properly or will not run
properly at high speed.
GR
Engine does not reach full speed
and / or emits excessive smoke
1. Check oil fuel mixture.
2. Air filter dirty.
TR
1. Use fresh fuel and the correct 2-cycle oil
mix.
2. Clean per instruction in Maintenance-
Air Filter Section.
3. Contact a Servicing Dealer for
carburetor adjustment.
3. Carburetor requires
adjustment.
CZ
SK
En gin e s t ar ts, r u ns and
accelerates but will not idle.
Carburetor requires adjustment.
Turn idle speed screw “T” (Fig. 30)
clockwise to increase idle speed.See
Operation-Carburetor Adjustment.
RUS
Bar and Chain Running Hot and
Smoking
1. Chain oil tank empty.
UK
2. Chain tension too tight.
PL
3. Oiler function.
H
1. Oil tank should be filled every time that
fuel tank is filled.
2. Tension chain per instructions in
Operation-Chain Tension section
(Pag. 28).
3. Run at full throttle 15 to 30 seconds.
Stop saw and check for oil dripping
from bar tip guard and guide bar. If oil
is present the chain may be dull or bar
may be damaged. If no oil contact a
Servicing Dealer.
LV
Engine starts and runs, but chain
is not rotating
1. Chain brake engaged.
EST
2. Chain tension too tight.
LT
3. Guide bar and chain assembly.
WA R N I N G : N e ve r
touch the chain while
the engine is running.
RO
4. Chain and/or guide bar
damaged.
5. Clutch drum and/or rim
sprocket damaged.
1. Release chain brake, see Operation-
Chain Brake Section (Pag. 31).
2. Tension chain per instructions in
Operation-Chain Tension section
(Pag. 28).
3. Refer to Assembly-Assembling the Bar
and Chain Section (Pag. 28).
4. Refer to Maintenance-Chain and/or
Maintenance-Guide Bar Section
(Pag. 33).
5. Replace if necessary - contact a
Servicing Dealer.
42