Текст страницы
3 Installation
Gas connection
• Product can be connected to gas
Never use a match or lighter to make
the gas leakage control.
C
• The flexible gas hose must be
A
supply system only by an au
thorised and qualified person or
technician with licence. Risk of
explosion or toxication due to un
professional repairs! Manufacturer
shall not be held responsible for
damages arising from procedures
carried out by unauthorised or un
licensed persons.
A
connected in a way that it does not
contact the moving parts around
it and is not trapped when the
moving parts are travelling. (e.g.
drawers). Besides, it should not be
placed in spaces where it might
get squeezed.
• Before starting any work on the
• The gas hose must not be
gas installation, disconnect the
gas supply. There is the risk of ex
plosion!
• Gas adjustment conditions and values are stated
clamped, bent or trapped or come
into contact with hot parts of the
product. There is the risk of explo
sion due to damaged gas hose.
Installing the product
1. Remove burners, burner caps and grills on the
hob from the product.
Your product is equipped for natural
gas (NG).
on labels (or on type label). C
2. Turning the hob upside down, place it on a flat
• Natural gas installation must be prepared before
surface.
installing the product.
3. When installing the hob, apply the sealing gasket,
• There must be a pipe (Piping advised to be buyed
which was provided in the packaging, around the
hob as shown in the following picture, ensuring
that it remains 1 to 2 mm inside from the outer
edge of the glass.
from a licensed installer), must comply with local
gas standard, at the outlet of the installation for
the natural gas connection of your product and
the tip of this pipe must be closed with a blind
plug. Service Representative will remove the
blind plug during connection and connect your
product by means of a straight connection de
vice (coupling).
• Make sure that the natural gas valve is readily
accessible. A
4. Place the hob on the counter and align it.
5. Using the installation clamps secure the hob by
If you need to use your product later
with a different type of gas, you must
consult the Authorised Service Agent
for the related conversion procedure.
Leakage check at the connection point
fitting through the holes on the lower casing.
• Make sure that all knobs on the product are
turned off. Make sure that the gas supply is open.
Prepare soapy foam and apply it onto the con
nection point of the hose for gas leakage control.
• Soapy part will froth if there is a gas leakage. In
this case, inspect the gas connection once again.
• Instead of soap, you can use commercially avail
able sprays for gas leak check.
18 / EN
Built-in Hob / User Manual