Текст страницы
9
EN
• Carefully remove the chopping knife (9) from the
bowl (8) holding it by the plastic end.
• Take the chopped products out of the bowl (8).
• Place the chopper bowl (9) on a flat and steady
surface.
• Install the chopping knife (10) on the axis inside the
bowl (9).
USING THE WHISK ATTACHMENT
ATTENTION! The blades of chopping knife (9) are very
sharp! Always hold the chopping knife (9) by the plastic
end.
Continuous operation time should not exceed 2
minute while using the whisk attachment (6). Make
at least a 2 minute break between two operation
cycles.
ATTENTION! Do not use the whisk attachment (6) to
knead tight dough.
• Use the whisk attachment (6) only for beating egg
whites, making biscuit dough or for mixing ready
desserts.
• Before installing the whisk attachment (6), make sure
that the power plug is not inserted into the mains
socket.
• Insert the whisk attachment (6) into the whisk gear
5).
• Insert the whisk gear (5) into the motor unit (2) and
turn it counterclockwise, make sure that the gear (5)
and the whisk (6) are fixed properly (fig. 3).
• Insert the power plug into the mains socket.
• Immerse the whisk attachment (6) into a suitable
bowl with food. You can put the foodstuffs into the
cup (10).
• To switch the unit on, press and hold down the button
(4) .
• For operation at the maximal rotation speed, press
and hold down the button (3) «TURBO».
• Put the products into the bowl (8).
• Note: do not switch the unit on when the bowl (8) is
empty.
• Install the geared lid (7) on the bowl (8).
• Install the motor unit (2) on the geared lid (7) feeding
chute, turn the geared lid (7) counterclockwise as
far as it will go, make sure that the motor unit (2) is
fixed properly. Install the motor unit (2) vertically and
evenly (pic. 2).
• Insert the power plug into the mains socket.
• To switch the unit on, press and hold down the button
(4) .
• For operation at the maximal rotation speed, press
and hold down the button (3) «TURBO».
• During the unit operation hold the motor unit (2) with
one hand and the chopper bowl (8) with the other
hand.
• Release the button (3 or 4) to switch off.
• After the unit operation, wait till the chopping
• knife (9) completely stops rotating.
• Remove the power plug from the mains socket.
• Disconnect the motor unit (2) from the geared lid (7)
by turning the motor unit (2) counterclockwise.
• Remove the geared lid (7) from the bowl (8).