Текст страницы
10
EN
• When you press and hold the button (4) you can
control the attachment rotation speed
• by turning the control knob (5).
• For operation at the maximal rotation speed, press and
hold down the button (3) «TURBO».
• Release the button (3 or 4) to switch off.
• After you finish using the unit, disconnect the power
plug from the mains socket, disconnect the whisk
gear (6) from the motor unit (2) by turning the gear (6)
clockwise.
• Remove the whisk attachment (7) from the gear (6).
• For operation at the maximal rotation speed, press
and hold down the button (3) «TURBO».
• When you make potato mash, add warm milk or
some potato pot liquor.
• After you finish the unit operation, take the power
plug out of the mains socket and remove the
attachment (11), turning it clockwise.
• Wash the lower part of the attachment (11), wipe the
outer part of the attachment (11) body with a damp
cloth. Do not immerse the attachment (11) into water
or other liquids.
POTATO MASH MAKING ATTACHMENT
CLEANING
ATTENTION! The blades of the chopping knife (10) are
very sharp and may be dangerous. Handle the chopping
knife (10) very carefully!
Continuous operation time should not exceed
1 minute while using the potato mash making
attachment (11). Make at least a 3-minute break
between operation cycles.
• Before installing the attachment (11), make sure that
the power plug is not inserted into the mains socket.
• Insert the attachment (11) into the motor unit (2), and
turn it counterclockwise as far as it will go, make sure
that the attachment (11) is fixed properly.
• Insert the power plug into the mains socket.
• Immerse the attachment (11) into the bowl with boiled
potatoes.
• To switch the unit on, press and hold down the button
(4).
• When you press and hold the button (4), you can
control the attachment rotation speed by turning the
control knob (5).
• Unplug the unit after you finish using it.
• Wash the whisk attachment (7), the chopper bowl (9),
the chopping knife (10) and the cup (11) with warm
water and a neutral detergent and dry them.
• Wash only the lower part of the blender attachment
(1), clean the outer surface with a slightly damp cloth.
Never immerse the blender attachment (1) into water
or any other liquids completely.
• Wipe the motor unit (2), the geared lid (8) and the
whisk attachment gear (6) with a soft slightly damp
cloth and then wipe them dry.
• After processing salty or sour products, it is
necessary to rinse the blender attachment (1) or the
chopping knife (10) with water immediately.