Текст страницы
10
EN
• Remove the gear cover (9) from the container (12) by
turning it counterclockwise.
• Carefully remove the blades (10, 11) from the
container (12) by holding the plastic shank.
• Remove the chopped food from the container (12).
USING A COFFEE GRINDER
the «TURBO» button (3). Continue grinding the coffee
beans in pulse mode until you get the desired grinding
result. Do not exceed the recommended operating time,
take breaks during operation.
• Remove the power plug from the mains socket.
• Disconnect the motor unit from the gear of the coffee
grinder (13) by pressing the release buttons (2).
• Remove the gear (13) from the container (14) by
turning it counterclockwise.
• Pour the ground coffee into the storage container.
The pulse mode time with the coffee grinder
attachment should not exceed 1 minute, after this
take a break for 1 minute. Take a break of at least 3
minutes after two operation cycles.
CLEANING
CAUTION! The cutting edges of the blades (10, 11) are
very sharp and can be dangerous. Handle the blades (10,
11) with extreme care!
• It is recommended to grind the necessary amount of
coffee beans right before the coffee making. Put the
unused coffee into a suitable sealed container.
• Remove the gear cover (13) from the container (14)
by turning it counterclockwise.
• Fill the container (14) with coffee beans.
• Install the gear (13) on the container (14) and tighten
the gear (13) along the thread, turning it clockwise
until it stops.
• Press the locks (2) and install the motor unit on the
gear of the coffee grinder (13), make sure that the
motor unit is securely fixed. Install the motor unit
vertically and without distortions.
• Insert the power plug into the mains socket.
• Turn the coffee grinder upside down with the
container (14) facing up.
• For grinding coffee beans, it is recommended to use
the pulse mode of the blender.
• To operate in pulse mode, press and hold the
«TURBO» button (3) for 10 seconds, then release
• After using the device, remove the power plug from the
mains socket, the indicator (5) will go out.
• Wash the whisk (7), chopper bowl (12), blades (10, 11),
coffee grinder container (14), cup (15) with warm water
and neutral detergent, rinse and dry them.
• Wash only the lower part of the blender attachment
(1), clean the outer surface with a slightly damp cloth.
Never immerse the blender attachment (1) in water or
any other liquids completely.
• Wipe the motor unit, cover gear (9), gear of the whisk
attachment (8), gear of the coffee grinder (13) with a
soft, slightly damp cloth, then wipe dry.
• The coffee grinder gear blades (13) can be cleaned of
ground coffee using a suitable brush.
• After processing salty or sour food, immediately rinse
the blender attachment (1) or blades (10, 11) with water.