Текст страницы
8
EN
Notes:
BATTERY CHARGING
ATTENTION!
– charge the battery at the temperature from +5°C to
+35°C.
– Use only the battery supplied with the unit. Using a
non-original battery can be dangerous.
– if you didn’t use the vacuum cleaner for more than
2-3 months, fully charge the battery before using the
vacuum cleaner.
– Do not expose Li-ion batteries to impacts and high
temperatures. Do not disassemble the battery to avoid
the electrolyte leakage.
USING THE VACUUM CLEANER
– Do not throw the battery into fire.
ATTENTION!
– Avoid the battery terminals circuit, it may cause burns
or fire.
– Do not discard the battery with usual household
waste, apply to a specialized center for further recycling.
– If the suction power of the vacuum cleaner decreases
rapidly while cleaning, switch it off immediately and
check the extension pipe (3) for obstruction. Remove
the obstruction and only then continue cleaning.
– Do not use the vacuum cleaner to collect burning or
smoking cigarettes, cinders, plaster or concrete dust,
flour or ashes.
– The vacuum cleaner is not intended for collecting
water or other liquids.
– Do not use the vacuum cleaner in places where
aerosols are used or sprayed, and in proximity to highly
inflammable liquids, do not use the vacuum cleaner in
the places where such liquids are stored.
ASSEMBLING THE VACUUM CLEANER
• Before using the unit for the first time or after a long
period of inactivity, charge the battery.
• Insert the power adapter (18) connection cord jack
(19) into the socket (11).
• Connect the power adapter (18) to the mains socket,
the indicator (7) will light up and start flashing. When
the battery is fully charged, the indicator (7) will glow
constantly.
• Full charging of the rechargeable battery takes about
4-5 hours.
• After charging the battery disconnect the power
adapter (18) from the mains.
• Remove the power adapter (18) connection cord jack
(19) from the socket (11).
• Install the dust bin on the motor unit of the vacuum
cleaner and make sure that the dust bin is properly
secured with the clamp (6) (pic. 1).