Текст страницы
you to use steam longer. In the «0» position, the steam supply is turned
off (dry ironing).
- COMPLETENESS
- Iron - 1 pc.
- Measuring cup - 1 pc.
- User manual - 1 pc.
STEAM STROKE
To use the steam shock function (powerful one-time steam emission), press
the «Steam Shock» button.
ATTENTION! Use the «Steam blow» button only after the iron is heated to
the steam production temperature. Do not press the steam shock button
more than three times in a row.
10. Use and store the appliance on a stable surface.
11. Do not operate the appliance if it has been dropped, has visible damage
or leaks water.
12. Do not connect the appliance to power supply via a timer or other
remote control device.
13. The surface of the heating element will remain hot for some time after
the appliance is turned off.
14. Accessible surfaces of the appliance can become very hot during
operation.
15. Special instructions for transportation (shipment) and sale: none.
4. WORKING PROCEDURE
Remove the protective film/cardboard from the sole of the iron. The steam
iron can use ordinary tap water. If the hardness of tap water exceeds 17° dH,
it is necessary to use distilled or demineralized (filtered) water to increase
the service life of the iron. Fill the water tank (for steam ironing). Disconnect
the iron from the mains and set the steam supply switch to the «0» position.
Fill in the water so that its level is visible approximately in the middle of
the transparent part of the iron body. Plug the iron into an electrical outlet.
ATTENTION! Before first use, try the iron out on a useless piece of fabric to
ensure that the sole or the water tank is not contaminated. Some parts
of the appliance are slightly lubricated during assembly; therefore some
smoke can occur when the iron is turned on for the first time. This should
disappear within a few seconds.
Auto-off: the iron will automatically turn off and the appliance will go into
standby mode after 30 seconds in a horizontal position or overturning and
8 minutes in a vertical position. When you turn off the iron, the auto-off
indicator will flash.
In order for the iron to heat up again, simply lift or move the appliance
slightly. The auto power off indicator will stop flashing. Instead, the heating
indicator will light up. The iron is ready for use again.
TEMPERATURE CONTROL
Sort the laundry according to the composition of the fabrics and the
appropriate ironing temperature. Iron products that require a lower
temperature first, since the iron heats up faster than it cools down. The
indicator lamp signals the heating of the iron. Turning off the lamp indicates
that the iron has reached the set temperature and You can start ironing.
5. CARE OF THE DEVICE
Set the temperature controller to the OFF position and disconnect the
iron from the mains. Place the iron in an upright position and let it cool
completely. Drain the water from the iron container. Set the steam supply
regulator to the «0» position. Remove deposits from the sole of the iron with
a solution of acetic acid. Wipe the iron body with a damp cloth, then wipe dry.
FUNCTIONS
SPRAYER
To spray water on the fabric, press the «Spray» button.
- APPLIANCE DESCRIPTION
- Sprayer
- Filler neck
- Steam switch
- Spray button
- Steam shock button
- Mode controller
- Ceramic-coated sole
- Indicator
DRY IRONING/STEAM
The steam supply intensity can be changed using the steam supply
regulator. In the ECO position, the steam supply speed is low, which allows
THERMAL PROTECTION
In case of failure of the iron thermostat, the device will automatically turn
off to avoid overheating. In this case, you should contact customer service.
9