Текст страницы
INSTRUCTION MANUAL
DEAR CUSTOMER!
CONGRATULATIONS ON YOUR GOOD CHOICE! NOW YOU ARE THE OWNER OF
ATLANTATM PRODUCT NOTABLE FOR ITS PROGRESSIVE DESIGN AND GOOD QUALITY
PERFORMANCE. WE HOPE OUR PRODUCTS WILL STAY WITH YOU FOR YEARS ON END.
BEFORE OPERATING
Please, read all these instructions carefully before using the appliance. We
recommend you to adheres to the distance from the nozzle to the hair at least 15cm.
Compliance with this requirement ensures the temperature effect on the hair at 57 ° C
which is perfect temperature for normal type of hairs. If you use a hair dryer for styling
you can use your short exposure to a small strand of hair with reduced distances of
up to 5 cm. The temperature effect in this case will be at 70 °C
SAFETY MEASURES
•
The device is designed to operate on two types of voltages. Please be sure the
voltage switch (E) have been set to the position corresponding the supply voltage
you are going to connect. Otherwise, hair dryer burn, and this item will be out of
warranty.
•
Do not allow water or any other liquid to go into the unit, as it can damage the
appliance.
•
After transportation in lower temperature conditions leave the appliance in a
warm room for at least two hours before switching it on.
•
The hair curling tongs is adjusted to function with the power supply specified in
the instruction.
•
Do not operate the appliance near objects that can be easily deformed by high
temperature.
•
Do not use this appliance near bathtubs, showers, basins or other vessels
containing water.
•
THE DEVICE IS NOT INTENDED FOR USE BY PERSONS (INCLUDING CHILDREN)
WITH REDUCED PHYSICAL, SENSORY OR MENTAL ABILITY OR IF THEY HAVE
NO EXPERIENCE OR KNOWLEDGE, IF THEY ARE NOT UNDER CONTROL OR NOT
INSTRUCTED ON THE USE OF THE INSTRUMENT THE PERSON RESPONSIBLE FOR
THEIR SAFETY.
• DO NOT LEAVE THE APPLIANCE UNATTENDED WHEN THEY IS PLUGGED IN OR
WHEN CHILDREN ARE AROUND. A POWER SUPPLY CORD MUST NOT BE HUNG
DOWN AS CHILDREN CAN PULL IT, THROW THE APPLIANCE AND GET BURNT.
•
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
3