Текст страницы
EN
EN
CONDTROL NEO X1-360/X2-360
CONDTROL NEO X1-360/X2-360
CROSS
LINE LASER
CROSS
LINE LASER
user manual
user manual
A
5. Turn the instrument by 180 ° and mark the point where laser lines
intersect each other on the opposite wall as A2 (A1, A2 must be on the
same vertical line) (see figure D).
D
2. Turn the instrument by 180°, mark the point where laser lines
intersect each other on the opposite wall as В2. (see Fig. В).
B
6. Measure distance dA between points A1 and A2 and dB between
points B1 and B2 (see Figure D). If deviation between dA and dB values
exceeds 3 mm, please contact the service center.
NEO X2-360
Use 2 parallel vertical walls which are located opposite each other at
a distance of 5 m.
1. Set the instrument close to the wall A (see Fig. A). Switch on the
vertical and horizontal laser emitters, unlock the compensator. Turn
the instrument in such a way so that the laser lines intersecting each
other are projected on the near wall A opposite the instrument. Mark
the point where laser lines intersect each other as A1.
12
13