Текст страницы
MANUAL
36
EN
DO NOT use heavily worn, damaged or
vibration-related work discs or discs with
visible mechanical incisions (chipping,
cracks, stratification).
a low temperature it is necessary to keep it
at room temperature for at least two hours.
5.3 When transporting, loading, unloading
and storing the product, in addition to the
requirements described in the operating
instructions, the following guidelines must
be observed: - do not expose the product
to significant mechanical loads that may
damage the product and /or affect the
integrity of the packaging; - it is necessary
to avoid getting water and other liquids on
the packaging of the product.
5.4 Before transport or transfer to storage
at a negative temperature in use, it must
be ensured that there is no water in the
product. All surfaces the products must be
dry.
5.5 Keep the product away from significant
temperature
fluctuations
and
direct
sunlight.
5.6 Improper disposal of the product causes
irreparable damage to the environment.
Do not throw away the defective product
and the used batteries together with the
household appliances waste. For this
purpose, contact a competent disposal
point. Addresses of collection points for
household goods, appliances and used
batteries for processing you can get in the
municipal services of your locality.
6 MAINTENANCE
6 MAINTENANCE
It is FORBIDDEN to use power tools
without a protective cover. Do not use
strongly worn, damaged or vibration-
related working tools or attachments with
visible mechanical damage (chipping,
cracks, stratification). The working tool or
nozzle must NOT be stopped with lateral
pressure. If the saw blade is jammed,
release the switch immediately and
remove the saw blade from the spindle.
Be careful when inserting the saw blade
into an already made cut. The cloth
must not be pinched. When the power
tool is switched on, move it towards the
workpiece/material to be machined. Do
not press hard on the power tool during
operation. The nozzle gets very hot during
operation. Do not put down the power tool
immediately after switching off, wait until
the motor is completely stopped. Always
try to hold the power tool so that dust and
small particles do not fly in your direction It
is FORBIDDEN to touch the working tool
until it is stopped and completely cooled.
In order to avoid overheating of the power
tool or the working tool, you should take
sufficient breaks in work to ensure cooling.
The tool is intended ONLY for dry work. Do
not use this product when working with wet
surfaces, in damp rooms or in rain/snow
to avoid electric shock. Keep your hands
outside the area to be treated to avoid
injury from contact with the working nozzle
5 WORKING PROCEDURE
5 WORKING PROCEDURE
6.1 After completion of the work, it is
necessary to clean the product from dust
and dirt. Special attention should be paid
to the ventilation openings. To clean the
case, do not use cleaning agents that can
cause rust to form on the metal parts of
the product or damage the plastic surface.
Wipe the body of the product with a damp
soft cloth, then wipe it dry.
6.2 Regularly check the reliability of all
screws. If a loose screw is found, tighten
it immediately. Otherwise, you are putting
yourself at risk of injury.
5.1
Store
the
product
at
ambient
temperatures from 0°C to +40°C and a
relative humidity of no more than 80% in a
place inaccessible to children and animals.
5.2 Transport the product only in the
original packaging to avoid damage. After
transportation or storage of the product at