Текст страницы
Warnings
After cleaning lubricate the thread and the sealing ring with polyal
phaolefin-based silica grease, e.g. Nyogel 760G. The application of
other types of grease is unacceptable. In case of active operation and
exploitation in dusty environments, it is recommended to perform
cleaning and lubricating of the parts as often as required.
For effective operation of the flashlight we recommend branded 18650
Li-Ion batteries without PCB (unprotected) no more than 70 mm long.
The flashlight can get hot in Turbo mode quickly and discharge the
battery with high current. Don’t leave it without your attention as very
bright light might heat objects and cause fire. It is forbidden to charge
the battery inside the flashlight when the ambient temperature is
below 0 °C.
WE DO NOT RECOMMEND to leave power sources inside the flash
light for a long storage period, as batteries (especially non-recharge
able) can leak for various reasons and damage the inner parts of the
flashlight. If you want to keep your flashlight in a stand-by state with
batteries in, previously install new and high-quality batteries, store
the flashlight in acceptable for batteries operational temperature and
revise the batteries' state at least once a month. If you have noticed any
signs of defects, withdraw the batteries from the flashlight and dispose
of them.
Warranty and Service
1. Always follow the instructions from this manual and recommenda
tions on battery usage.
2. Apply only the recommended power sources.
Armytek provides free warranty repairs for 10 years (excluding bat
teries, chargers, switches and connectors, which have 2-year warran
ty) from the date of purchase if there is a document confirming the
purchase. The warranty does not extend to damage during:
3. Do not reverse battery polarity.
1. Improper usage.
4. Do not modify or recast the flashlight and its components as it will
2. Attempts to modify or repair the flashlight by nonqualified
deprive you of the warranty.
specialists.
5. Do not allow water or any other liquid to leak into the flashlight.
3. Application in chlorinated, contaminated liquids or sea water.
6. Do not aim a switched-on flashlight at people's or animals' eyes – it
4. Immersion into liquids in case of broken leakproofness.
can cause temporary blindness.
5. Exposure to high temperatures and chemicals, including the liquids
7. Do not allow children to use the flashlight without your assistance.
from defected batteries.
6. Usage of low-quality batteries.
The producer will not be liable for any harm done to the user if it
was caused by improper use of the product.
Armytek
Germany, 10551 Berlin, Jonasstraße 6
+1 (206) 785-9574, service@armytek.com
www.armytek.com
Care and Storage
It is recommended to clean the threads and O-rings off dirt and old
grease once or twice per year. Remember that reliable protection from
water and dust cannot be provided by worn out sealing. The fouling
as well as lack of lubricant cause fast wear-out of threads and sealing
rings.
To clean the threads do the following:
1. Unscrew the tailcap and remove the sealing ring carefully with a
toothpick (do not use sharp metal things as they can damage the
ring).
2. Wipe the sealing ring thoroughly with a soft cloth (or tissue). Do not
use solvents. If the sealing ring is worn out or damaged replace it by
a new one.
3. Clean the metal threads with a brush using ethanol. Be careful not to
allow the applied liquid to get inside the flashlight or tailcap as it can
cause fails in functionality of the flashlight.
4
ENG USER MANUAL WIZARD C2
REV_00-0003