Текст страницы
ASSEMBLY
FUNCTIONAL DESCRIPTION
CAUTION: Always be sure that the tool is
switched off and unplugged before carrying out
any work on the tool.
CAUTION: Always be sure that the tool is
switched off and unplugged before adjusting or
checking function on the tool.
Installing or removing trimmer bit
Adjusting trimmer bit protrusion
CAUTION: Do not tighten the collet nut with-
out inserting a trimmer bit, or the collet cone will
break.
CAUTION: Use only the wrenches provided
with the tool.
To adjust the bit protrusion, loosen the clamping screw
and move the base up or down as desired by turning
the adjusting screw. After adjusting, tighten the clamp-
ing screw firmly to secure the base.
► Fig.1: 1. Base 2. Scale 3. Bit protrusion 4. Clamping
screw 5. Adjusting screw
Switch action
Insert the trimmer bit all the way into the collet cone and
tighten the collet nut securely with the two wrenches.
To remove the bit, follow the installation procedure in
reverse.
► Fig.4: 1. Loosen 2. Tighten 3. Hold
CAUTION: Before plugging in the tool, always
be sure that the tool is switched off.
OPERATION
To start the tool, move the switch lever to the I position.
To stop the tool, move the switch lever to the O position.
► Fig.2: 1. Switch lever
CAUTION: Always hold the tool firmly with
one hand on housing. Do not touch the metal part.
Electronic function
1.
Set the base on the workpiece to be cut without
the trimmer bit making any contact.
The tool is equipped with the electronic functions for
easy operation.
2.
Turn the tool on and wait until the trimmer bit
attains full speed.
Indication lamp
► Fig.3: 1. Indication lamp
3.
Move the tool forward over the workpiece surface,
keeping the base flush and advancing smoothly until
the cutting is complete.
► Fig.5
The indication lamp lights up green when the tool is
plugged. If the indication lamp does not light up, the
mains cord or the controller may be defective. The indi-
cation lamp is lit but the tool does not start even if the
tool is switched on, the carbon brushes may be worn
out, or the controller, the motor or the ON/OFF switch
may be defective.
Unintentional restart proof
When doing edge cutting, the workpiece surface
should be on the left side of the trimmer bit in the feed
direction.
► Fig.6: 1. Workpiece 2. Bit revolving direction
3. View from the top of the tool 4. Feed
direction
The tool does not start with the switch lever in I position
even when the tool is plugged.
At this time, the indication lamp blinks in red and shows
the unintentional restart proof device is on function.
To cancel the unintentional restart proof, return the
switch lever to O position.
When using the straight guide or the trimmer guide,
be sure to keep it on the right side in the feed direc-
tion. This will help to keep it flush with the side of the
workpiece.
► Fig.7: 1. Feed direction 2. Bit revolving direction
3. Workpiece 4. Straight guide
Soft start feature
Soft-start feature minimizes start-up shock, and makes
the tool start smoothly.
NOTE: Moving the tool forward too fast may cause
a poor quality of cut, or damage to the trimmer bit or
motor. Moving the tool forward too slowly may burn
and mar the cut. The proper feed rate will depend on
the bit size, the kind of workpiece and depth of cut.
Before beginning the cut on the actual workpiece, it
is advisable to make a sample cut on a piece of scrap
lumber. This will show exactly how the cut will look as
well as enable you to check dimensions.
10
ENGLISH