Текст страницы
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
DTW284
DTW285
Fastening capacities
Standard bolt
M10 - M20
High tensile bolt
M10 - M16
Square drive
12.7 mm
No load speed
Hard impact mode
0 - 2,800 min
-1
Medium impact mode
0 - 2,100 min
-1
Soft impact mode
0 - 1,600 min
-1
Impacts per minute
Hard impact mode
0 - 3,500 min
-1
Medium impact mode
0 - 2,600 min
-1
Soft impact mode
0 - 1,800 min
-1
Overall length
147 mm
Rated voltage
D.C. 14.4 V
D.C. 18 V
Battery cartridge
BL1415, BL1415N
BL1430, BL1430B,
BL1440, BL1450,
BL1460B
BL1815, BL1815N,
BL1820, BL1820B
BL1830, BL1830B,
BL1840, BL1840B,
BL1850, BL1850B,
BL1860B
Net weight
1.4 kg
1.6 kg
1.5 kg
1.7 kg
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications and battery cartridge may differ from country to country.
•
Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
Noise
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
The typical A-weighted noise level determined accord-
ing to EN60745:
Sound pressure level (LpA) : 96 dB(A)
Sound power level (LWA) : 107 dB (A)
Uncertainty (K) : 3 dB(A)
WARNING: The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING: Wear ear protection.
Vibration
WARNING: Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Model DTW284
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (ah) : 14.0 m/s
2
For European countries only
Uncertainty (K) : 1.5 m/s
2
The EC declaration of conformity is included as Annex A
to this instruction manual.
Model DTW285
Work mode: impact tightening of fasteners of the maxi-
mum capacity of the tool
Vibration emission (ah) : 11.5 m/s
2
Uncertainty (K) : 1.5 m/s
2
4
ENGLISH