Текст страницы
Changing the application mode
This tool employs several easy-to-use application modes for driving bolts with good control.
The type of the application mode changes every time you press the button
.
NOTE: You can extend the time to change the application mode approximately one minute if you press the but-
ton
or
.
► Fig.8
Application mode
(Assist type displayed on panel)
Feature
Purpose
Clockwise
Preventing over tightening of bolts.
Counterclockwise
Loosening bolts.
Bolt mode
Clockwise
This mode helps to repeat screwdriving
continuously with equal torque. This mode
also helps to reduce the risk of breakage
of bolts/nuts due to overtightening.
Counterclockwise
This mode helps to prevent a bolt from
falling off. When loosening a bolt with the
tool driving in counterclockwise rotation,
the tool automatically stops or slows down
after the bolt/nut gets enough loosened.
NOTE:
The timing to stop the driving varies
depending on the type of the bolt/nut
and material to be driven. Make a test
driving before using this mode.
–
Bolt mode (1)
Clockwise
The tool stops automatically as soon as
it has started impact blows.
Counterclockwise
The impact force is 4. The tool stops
automatically as soon as it has loos-
ened the bolt/nut.
–
Bolt mode (2)
Clockwise
The tool stops automatically approx-
imately 0.5 second later from the
moment that the tool has started impact
blows.
Counterclockwise
The impact force is 4. The tool stops
automatically as soon as it has loos-
ened the bolt/nut.
–
Bolt mode (3)
Clockwise
The tool stops automatically approxi-
mately 1 second later from the moment
that the tool has started impact blows.
Counterclockwise
The tool slows down the rotation after it
has loosened the bolt/nut.
: The lamp is on.
NOTE: When none of the lamp on the panel is lit, pull the switch trigger once before pressing the button
.
NOTE: All lamps on the switch panel go out when the tool is turned off to save the battery power. The type of the
application mode can be checked by pulling the switch trigger to the extent that the tool does not operate.
Full speed mode
ASSEMBLY
► Fig.9: 1. Button
2. Lamp
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Selecting correct impact socket
When full speed mode is turned on, the tool speed becomes
fastest even if you do not pull the switch trigger fully. When
full speed mode is turned off, the tool speed increases as
you increase the pressure on the switch trigger.
To turn on full speed mode, press and hold the button
. To
turn off full speed mode, press and hold the button
again.
The lamp turns on while full speed mode is on.
NOTE: Full speed mode continues even after switch-
ing the impact force mode/auto stop mode.
Always use the correct size impact socket for bolts and
nuts. An incorrect size impact socket will result in inac-
curate and inconsistent fastening torque and/or damage
to the bolt or nut.
9
ENGLISH