Текст страницы
6-1. Protector
7-1. Brush holder cap
7-2. Screwdriver
ENGLISH
Explanation of general view
1-1. Switch trigger
2-1. Side grip
2-2. Groove
3-1. Socket
3-2. Anvil
4-1. O-ring
4-2. Pin
5-1. Limit mark
SPECIFICATIONS
Model
TW1000
Standard bolt
M22 - M30
Capacities
High tensile bolt
M22 - M24
Square drive
25.4 mm
No load speed (min-1)
1,400
Impacts per minute
1,500
Max. fastening torque
1000 N.m
Overall length
382 mm
Net weight
8.4 kg
Safety class
/II
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
000087
• Note: Specifications may differ from country to country.
ENE036-1
Intended use
The tool is intended for fastening bolts and nuts.
ENF002-1
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
ENG006-2
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 103 dB (A)
sound power level: 114 dB (A)
Uncertainty: 1 dB(A)
Wear ear protection.
The typical weighted root mean square acceleration
value is 15 m/s2.
These values have been obtained according to
EN60745.
For Model TW1000
ENH101-5
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN60745, EN55014, EN61000 in accordance with
Council Directives, 89/336/EEC, 98/37/EC.
Yasuhiko Kanzaki CE2005
Director
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
GEB009-2
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to recipro saw safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious
personal injury.
1.
Hold power tools by insulated gripping
surfaces when performing an operation where
the cutting tool may contact hidden wiring or
its own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and shock
the operator.
2.
Wear ear protectors.
3.
Check the socket carefully for wear, cracks or
damage before installation.
4.
Hold the tool firmly.
5.
Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
6.
The proper fastening torque may differ
depending upon the kind or size of the bolt.
Check the torque with a torque wrench.
3