Текст страницы
ХОЛОДИЛЬНИК
REFRIGERATOR-FREEZER
CONTROL PANEL
model: KF-DС230W, KF-DС230X
model: KF-DС290W, KF-DС290X
1. Before connecting the Fridge/Freezer to the mains supply position. The thermostat
control dial is located inside the Fridge compartment.
2. Turn the thermostat knob to the “4” position and turn on the electricity. The compressor
and the light inside the refrigerator will begin to work.
3. Wait 24 hours before placing food into the Fridge/Freezer, the temperature inside your
Fridge/Freezer will then be cool enough to chill and freeze foods sufficiently.
Adjusting the temperature
1. The temperature in the refrigerator and freezer compartment is controlled by the
temperature controller installed on the inside wall of the refrigerator compartment.
We strongly recommend you use a freezer thermostat to check that the temperature
is below -18 centigrade before loading any food. This can take 2-3 hours.
2. The marks on the knob are the temperature grades, NOT the exact degrees of
temperature. “0” is OFF and “7” represents the lowest temperature.
3. Please start with the knob set to position “4”. Use a suitable thermometer to check the
temperature after two hours. To reduce the refrigerator temperature turns the knob
towards and check after one hour.
NOTE: The Fridge/Freezer may not operate at the correct temperature if it is in a
particularly hot or cold room or is you open the Fridge/Freezer door too often.
DAILY USE
Take extra care with meat and fish
Cooked meats should always be stored on a shelf above raw meats to avoid bacterial
transfer. Keep raw meats on a plate which is large enough to collect juices and cover it
with cling film or foil.
Leave space around food
This allows cold air to circulate around the Fridge, ensuring all parts of the Fridge are
kept cool.
25
ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE