Текст страницы
4. Remove the freezer door body (be careful not to lose small parts such as the
shaft sleeves and door stoppers);Remove the lower hinge shaft and install it on
the other side of the hinge for backup use.
EN
5. Refrigeration door replacement;Remove the left trim cover, take out the
right trim cover from the accessory bag and install it on the other side of the
upper end cap; remove the fridge door self-locking and door stop, take out
the left door self-locking from the accessory bag, and install the door stop
and left door self-locking to the left side of the lower end cap of the door in
turn. Remove the bottom screws, disconnect the
signal line, remove the
recognized human detect sensor module (reserved) and insert the wiring
harness into the hole.Remove the left bottom cover and install it to the right
bottom. Pull out the
signal line, connect it with the recognized human detect
sensor module, fix it and tighten the screw. All wire harnesses must be fully
inserted into the slots to avoid exposure.
6. Remove the upper end cap sleeve of the freezer door, and install the cap in the
left and right interchangeable positions;Remove the freezer door self-locking,
the door stopper and the door support, remove the left door self-locking from
the accessory package, install the door stopper and the left door self-locking to
the left side of the freezer lower end cover in turn, and install the door support
to the right side of the freezer lower end cover.
07