Текст страницы
Perimeter setting interface
(1) Select the rule number, set the event as the perimeter, and check [Enable] to enable the rule.
(2) Draw the perimeter detection area.
(3) Select the detection mode. In entry mode, an alarm will be triggered in the area where the target
entered; in leaving mode, an alarm will be triggered in the area where the target left; in intrusion
mode, an alarm will be triggered when the target is kept in the detection area for the time
specified for intrusion.
(4) Set the intrusion time, which means that an alarm will be triggered when the target is kept in the
detection area for the time specified.
(5) Click save after setting.
[Event Type] = > [Behavior Analysis] = > [Object Abandone]
103