Текст страницы
⑩ Speaker
Installation Hole for Mount
mount.
⑦ Hold the camera by hand and adjust the
How to Install
Illustration C
① Rotate counterclockwise to disassemble the
angle. After adjustment, tighten the locking
cap.
Note: Please install the camera with its power
port facing downwards. When the power port
is not used, please cover it with the protective
cover to prevent water ingress.
mount.
a. Locking Cap b. Base
② Select a suitable mounting position (it is
How to Use
recommended to be 2–3 m above the ground
and there are no buildings or trees around
the mounting wall surface), and then place
the mounting template sticker on a flat wall
surface.
③ Drill holes (each hole has a diameter of 6 mm
and a depth of 30 mm) and install wall plugs.
④ Fix the base to the wall with screws.
⑤ Fix the locking cap onto the base.
⑥ Hold the camera by hand and fix it to the
Charging: Please fully charge the camera before
use. Connect the charging cable and a power
adapter with an output of 5 V = 2 A, and then
switch on the power to charge the camera.
Turning on/off: Press and hold the configuration
button for approx. 3 seconds.
Resetting the device: Press and hold the
configuration button for approx. 7 seconds while
the camera is turned on.
06