Текст страницы
EN
To connect the cooker to a gas cylinder, screw on a
min. 0,5 m long metal junction pipe provided with an
end junction hose (8 x 1 mm) onto the lead-in pipe.
The gas-supply pipe must not get in contact with
the protective metal elements on the cooker’s rear
wall. Check up if the junctions are leak-proof.
It is advisable to tighten the junctions by insulating
teflon tape.
Overtightening (max. tightening torque – 20 Nm) or
using glue can result in junction damage and lead
to gas leak.
In plant, the gas cooker has been pre-adjusted for
operating on AC power and single-phase current
(230 volt ~ 50 hz). First check up if the AC outlet
complies with the cooker’s electric capacity, and
then plug in.
The power outlet should have a zero phase.
Cautions: CHECK UP LEAKPROOFNESS
of the connection to the gas supply pipe or
gas cylinder using soap suds only. Don’t
use open flame – danger to life!
10