Текст страницы
BACK PANEL / SENSORS
HEPA FILTER / DEODORIZING FILTER
Remove the dust on the filters.
Remove the dust gently with a cleaning
tool such as a vacuum cleaner.
HEPA Filter
Sensors
Sensors
Clean only the tagged surface. Do not clean up the
opposite surface. The filter is fragile, so be careful
not to give too much pressure.
Tag
Back Panel (Pre-Filter)
Deodorizing Filter
NOTE
Both surfaces can be cleaned. The filter may be
broken if being too much pressure is applied on it,
so please handle it with care.
• Do not apply excessive pressure when
scrubbing the Back Panel.
(KI-N41R)
(KI-N51R)
NOTE How to clean hard to remove dirt.
Back Panel
Back Panel
NOTE
1. Add a small amount
of kitchen detergent to
water and soak for about
10 minutes.
2. Rinse off the kitchen
detergent with clean
water.
3. Completely dry the filter
in a wellventilated area.
Sensor Filter
Sensor Filter
1. Remove the Back Panel.
2. Remove the Sensor
Filter.
3. If the Sensor Filter is very
dirty, wash it with water
and dry it thoroughly.
• Do not wash the filters. Do not expose to
sunlight. (Otherwise these filters may lose
efficacy.)
• Some odors absorbed by the filters will
break down over time, causing additional
odors. Depending on usage conditions,
and especially if the product is used in
environments significantly more severe than a
normal household, these odors may become
noticeable sooner than expected.
Replace the filter in those cases or if dust is
unable to be removed after maintenance.