Текст страницы
EMPTYING AND CLEANING THE INTERNAL PIPES
Before using the machine again after long breaks (e.g, vacation), the machine must e rinsed thoroughly. This short procedure serves to thoroughly
purge and clean the internal piping.
Procedure
1. Fill the water tank with water (see "Getting Started".)
2. Connect the device to the mains socket.
3. Press the start button.
4. The LEDs on the buttons will stabilize when the machine has warmed up. The warm-up time is approximately 45 seconds.
Before pressing the Brew button, make sure that:
· The compartment lever is closed and there are no capsules inside.
· The water tank is full.
· The water tank is firmly in place, otherwise the water may leak.
- Place a Volume(size 250ml or larger) under the dispenser.
- Press the Brew button and wait for the appliance to complete the rinse.
- Do not lift the lever until the rinsing process stops automatically.
DECALCIFICATION OF THE MACHINE
Drinking water varies by region. Lime particles from potable water are deposited as waste in the machine and can block the pipe and cause damage. To
avoid this, be sure to decalcify the machine at least after making 300 to 400 cups of coffee or, in any case, if production drops significantly or after one or
two months.
Decalcification must be done correctly to avoid damage.
Carefully follow the instructions below.
1. Fill the tank with a mixture of water and a commercially available decalcifying liquid for coffee makers (always follow the manufacturer's instructions).
2. Make sure there are no capsules inside the machine.
3. Place a large container under the dispensing head to collect the mixture and lime residue
4. Press the Volume button to perform decalcification. Repeat the process several times until all the water in the tank is used up.
5. Repeat the process to rinse the internal circuit with a tank of clean water (no decalcifying liquid) to completely clean the internal circuit and ensure the good taste of
your drinks.
lmportant
· Use extreme caution with hot water!
· Never clean the machine with vinegar. This will damage the machine and make the drinks taste bad.
· Damage caused by incorrect decalcification or lack of decalcification is not covered by the warranty.
SECURITY WARNINGS
Do not wet the machine or put it in the water.
Do not lift the top cover while using the brewer.
There is a sharp needle on the top of the capsule adapter.
Do not place your hand underneath or near it as it may get punctured.
Do not touch the top of the adapter when removing it from the
compartment, as it is very hot and could cause burns.