Текст страницы
6
EN
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Do not leave children unattended to prevent using
the unit as a toy.
• Do not allow children to touch the unit and the power
cord during the coffee maker operation.
• Place the unit out of reach of children during the
operation and cooling down.
• This unit is not intended for usage by physically or
mentally disabled persons (including children) or
• by persons lacking experience or knowledge if
they are not under supervision of a person who
is responsible for their safety or if they are not
instructed by this person on the usage of the unit.
• From time to time check the power cord and the
power plug integrity.
• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or
similar qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not
disassemble the unit by yourself, if any malfunction
is detected, and after it was dropped, unplug the unit
and apply to the service center.
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
• Unpack the coffee maker and remove all the
packaging materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit
correspond to the specifications of your mains. When
the unit is used in the mains with 60 Hz frequency, it
does not need any additional settings.
• Wipe the surface of the coffee maker body with a
clean, slightly damp cloth to remove dust.
• Open the lid (6), take the filter holder (4) and the
reusable filter (5) out.
• Wash all removable parts: the coffee flask (1), the
flask lid (3), the filter holder (4), and the filter (5) with
warm water and a neutral detergent, rinse them and
dry.
• Place the filter holder (4) in its installation place.
Make sure the filter holder (4) is installed correctly,
otherwise the lid (6) will not close.