Текст страницы
10
EN
RETURN TO THE FACTORY SETTINGS
pressure in the boiler is released, you can remove
the filter holder (5).
ESPRESSO PORTION SETTING
• Switch the coffee maker on and wait for preheating, the
button (18, 19, 20) indicators will light up.
• After the preheating is finished, press and hold
simultaneously the buttons (20) «
» and (19) «
» for 3 seconds, the buttons (19 and 20) illumination will
flash 3 times, and the espresso machine will return to the
factory settings.
• Switch the coffee maker off by pressing the on/off button
(17) «
», the buttons (17, 18, 19, 20) illumination will
go out.
• Switch the coffee maker on by pressing the on/off button
(17) «
», the settings will return to default.
MAKING CAPPUCCINO
ATTENTION!
Be careful to avoid burns by the released hot steam.
-
To enter the programming mode, press and hold
the one cup button (18) «
» for 3 seconds, the
button (18) «
» illumination will be flashing.
Press the button (18) «
» again. After the
required amount of ready coffee is poured into the
cup, press the button (18) «
» again to finish
setting. Maximum time of water supply for making
one cup of coffee is 45 seconds.
-
To enter the programming mode, press and hold
the two cups button (19) «
» for 3 seconds,
the button (19) «
» illumination will be
flashing. Press the button (19) «
» again. After
the required amount of ready coffee is poured into
the cup, press the button (19) «
» again to
finish setting. Maximum time of water supply for
making two cups of coffee is 90 seconds.
Notes:
• Make coffee, as described in the chapter «MAKING
ESPRESSO», in a cup with enough capacity to add
frothed milk.
• Make sure that the steam control knob (9) «
» is in
the position «the steam supply is off «•».
• Press the steam supply button (19) «
» and wait until
the button (20) «
» illumination glows constantly. Place
any suitable bowl under the tip (11) for water. Carefully
turn the steam supply knob (9) «
» counterclockwise
for a quarter of a turn to remove the condensed fluid from
the cappuccinator pipe (10).
-
if you have programmed the water supply time
for making one cup of coffee, then the water
supply time for making two cups of coffee will be
automatically set doubled;
-
water supply time for two cups of coffee can be set
up to 90 seconds. If the water supply time for two
cups of coffee was set, then the water supply time
for making one cup of coffee will be automatically
set as half the time for making two cups of coffee.