Текст страницы
13
EN
REMOVING MINERAL SCALE
For effective operation of the coffee maker we recommend
removing scale every 2-3 months and when using »hard”
water more often.
necessary, switch the water supply off by pressing the
button (19) «
» again. Pour the liquid out from the
cup.
10. Switch the water supply on by pressing the button (19)
«
» and fill a cup of about 100 ml capacity, press
the button (19) «
» again to switch the water supply
off and pour the liquid out of the cup.
11. After a while repeat the procedure described in the
paragraph 10 and fill the cup of about 100 ml capacity
again.
12. Press the steam supply button (20) «
». Put a
suitable bowl under the tip (11) and slightly open
the steam supply by turning the knob (9) «
»
counterclockwise. Carefully turn the knob (9) «
»
to the maximal steam release position, release the
steam for about 1 minute, then close the steam by
turning the knob (9) «
» clockwise until bumping
«•».
13. Switch the coffee maker off by pressing the on/off
button (17) «
»,. Wait for 10-15 minutes.
14. Perform the steps 10 and 11 at least 3 times.
15. Repeat the cleaning procedure for the steam release
channels described in the paragraph 12.
16. With small intervals, repeat the boiler cleaning
procedure (paragraph 10) until the citric acid solution
dissolves in the tank (20) completely.
17. Switch the coffee maker off by pressing the on/off
button (17) «
».
1.
Make sure that the power plug is not inserted into the
mains socket.
2.
Make sure that the steam supply is closed. To do this
turn the knob (9) «
» clockwise until bumping
«•».
3.
Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water tank
(15). Install the tank (15) back to its place.
4.
Insert one of the coffee filters (6) into the holder (5).
Do not put ground coffee into the filter (6).
5.
Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the filter holder
handle (4) to the right until bumping «LOCK».
6.
Place a suitable cup on the grid (2).
7.
Insert the power plug into the mains socket.
8.
Switch the coffee maker on by pressing the on/off
button (17) «
», the button (17) illumination will
light up, when the buttons (18, 19, 20) illumination
lights up, it means preheating is completed.
9.
Press the button (19) «
», depending on the
preset water supply time, press the button (19) «
» once or twice, fill a cup of approximately 100 ml
capacity with water (it is necessary to remove water
from the boiler and fill it with citric acid solution), if