Текст страницы
ENG
Filtration System Installation Process
Figure 4.1.
4. HOOKUP
- Hang the filter housing (the rack
holding the filter elements) on the
screwed-in self- tapping screws.
Figure 4.2.
- Unscrew the nut from the ball valve and
put it on the plastic tube (Figure 4.1).
- Apply force, pull the tube onto the
ball valve and tighten the nut
(Figure 4.2).
Figure 4.3.
- Push the other end of the plastic
tube as far as it will go into the
fitting on the inlet (marked with
«IN») on filtration system housing.
For proper installation the tube
must be 17 mm deep in fitting (for
all fittings). (Figure 4.3).
Figure 4.4.
- Push one end of another white
plastic tube as far as it will go into
the straight fitting of the filtered
water spigot (Figure 4.4).
Figure 4.5.
- Push the other end of this second
white plastic tube as far as it will
go into the outlet fitting (marked
with «OUT») in the filtration system
housing (Figure 4.5).
18