Текст страницы
SPLIT-TYPE ROOM AIR CONDITIONER
the remote control is lost and it is absolutely necessary. To restore regular operation,
use the remote control to activate the unit. Unit must be turned off before manual
operation. To operate your unit manually:
- Open the front panel of the indoor unit.
- Locate the MANUAL CONTROL button on the right-hand side of the unit.
- Press the MANUAL CONTROL button one time to activate FORCED AUTO mode.
- Press the MANUAL CONTROL button again to activate FORCED COOLING mode.
- Press the MANUAL CONTROL button a third time to turn the unit off.
- Close the front panel.
Note! Do not move louver by hand. This will cause the louver to become out of sync.
If this occurs, turn off the unit and unplug it for a few seconds, then restart the unit. This
will reset the louver.
CAUTION! Do not put your fingers in or near the blower and suction side of the unit. The high-speed fan inside the unit may
cause injury.
CLEANING AND CARE
WARNING! Before it is cleaned or serviced, the appliance must be disconnected from the
electric power source.
Only use a soft, dry cloth to wipe the unit clean. If the unit is especially dirty, you can use
a cloth soaked in warm water to wipe it clean.
• Do not use chemicals or chemically treated cloths to clean the unit.
• Do not use benzene, paint thinner, polishing powder or other solvents to clean the unit.
They can cause the plastic surface to crack or deform.
• Do not use water hotter than 40°C to clean the front panel. This can cause the panel to
deform or become discolored.
• Drying with a microfiber or soft cloth is preferred.
• Do not spray water on the conditioner or immerse the appliance in water.
IMPORTANT! Never use abrasive tools. Do not clean with a jet of steam.
Note! The manufacturer of this appliance does not take responsibility for damages caused by
chemicals or abrasive cleaning.
CLEANING AIR FILTER
A clogged air conditioner can reduce the cooling efficiency of your unit, and can also be
bad for your health. Make sure to clean the filter once every two weeks.
1. Lift the front panel of the indoor unit.
2. First press the tab on the end of filter to loosen the buckle, lift it up, then pull it towards
yourself.
3. Now pull the filter out.
4. If your filter has a small air freshening filter, unclip it from the larger filter. Clean this air
freshening filter with a hand-held vacuum.
5. Clean the large air filter with warm, soapy water. Be sure to use a mild detergent.
6. Rinse the filter with fresh water, then shake off excess water.
7. Dry it in a cool, dry place, and refrain from exposing it to direct sunlight.
8. When dry, re-clip the air freshening filter to the larger filter, then slide it back into the indoor unit.
9. Close the front panel of the indoor unit.
BATTERY
CAUTION! Do not touch air freshening (Plasma) filter for at least 10 minutes after turning
off the unit.
1. Slide the back cover from the remote control downward, exposing the battery
compartment.
2. Insert the batteries, paying attention to match up the (+) and (-) ends of the
USER GUIDE
30