Текст страницы
2. INSTALLATION INSTRUCTIONS
Wall Mounting
1. Open the packing box and take out the convector with its protective nylon cover. Tear the
protective nylon cover outside the box without giving any harm to the appliance and take out the
hangers attached on the unit by pulling the springs thereon.
2. Correct space has to be measured in order that the connection cord can easily be connected to
the electric socket. After determining the place the holes for montage must be drilled according to
the method shown in Figure 7. To fix this appliance you can use the wall mounting bracket. (Figure
5) Mounting bracket can be used as a template for positioning and drilling points. You can place
the bracket on the wall and measure the space between the floor and the lower part of the bracket
as min 100 mm or max. 200 mm. Mark the screw-holes through the holes with an appropriate
pen. You have to be careful to ensure the safety zones are kept free in order that the appliance can
work efficiently. (Figure 6.)
3. After marking the points, the holes will be drilled by a Ø9 mm drill and the plastic dowels that
are in the montage items are driven to these holes.
4. Wall mounting brackets supplied with the unit has to be fixed securely to the wall.
Note: By adding the requested height difference to these measures the height can be arranged
as demanded.
Spring
Clip
Dowel
Screw
(H)
Lower Mount
Figure 6. Minimum safety zones
required for the efficiency of the
appliance
Figure 5. Wall mounting
brackets
Model
A
H (min/max)
Figure 7.
Centering
holes
EPK4550
280 mm (28 cm)
100/200 mm
EPK4570
400 mm (40 cm)
EPK4590
600 mm (60 cm)
207
16