Текст страницы
SAFETY INSTRUCTIONS
• Electric panel convector heaters has been adjusted for 220-240 V. Therefore use the
convector only with the Alternative Voltage (AC) and sufficient current rated power
outlets.
• Use your electric panel convector heater with grounded plug socket. Our company will
not be deemed responsible for the damages caused due to use without the application
of grounding.
• Always operate heater in an upright position. Before operating read montage
instructions carefully.
• Always check heater after you open the package. Call the Distributor’s Consumer
Advisory Hotline in case a breakdown or damage. Never mount or use your heater. Please
refer to the dealer with warranty card and bill.
• If you use wheel set, heater should be positioned on a flat surface.
• Unplug of your electric panel convector heater from the mains socket while not in use
for long periods and before cleaning.
• Do not place the cord in traffic areas otherwise it may be tripped over.
• Protect your electric panel convector heater against impacts and crushes during
carriage, assembly and use.
• Do not use your electric panel convector heater for any other purpose than its intended
use for. Do not place cloth thereon.
• Do not operate in areas where gasoline, paint or other flammable liquids are used or
stored.
• Do not immerse in liquid or allow liquid into the interior of the appliance, as this could
create an electric shock hazard.
• Protect the heating cable of your electric panel convector heater against potential
tension possibilities. Do not unplug by pulling on cord.
• Do not operate appliance with wet hands always ensure that hands are dry before
operating any switch on the product or touching the plug.
8