Текст страницы
1. High Definition Audio supports Jack Sensing, but the panel wire on the chassis
must support HDA to function correctly. Please follow the instructions in our
manual and chassis manual to install your system.
2. If you use an AC’97 audio panel, please install it to the front panel audio header by
the steps below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for the HD audio panel only. You don’t need to
connect them for the AC’97 audio panel.
E. To activate the front mic, go to the “FrontMic” Tab in the Realtek Control panel
and adjust “Recording Volume”.
4 3 2 1
This motherboard provides two
4-Pin water cooling chassis fan
connectors. If you plan to con
FAN_SPEED_CONTROL
Chassis/Water Pump Fan
Connectors
(4-pin CHA_FAN1/WP)
(see p.6, No. 4)
nect a 3-Pin chassis water cooler
FAN_VOLTAGE
CHA_FAN_SPEED
GND
fan, please connect it to Pin 1-3.
FAN_SPEED
FAN_SPEED_CONTROL
GND
FAN_VOLTAGE_CONTROL
(4-pin CHA_FAN2/WP)
(see p.6, No. 13)
FAN_SPEED
This motherboard
FAN_SPEED_CONTROL
GND
FAN_VOLTAGE_CONTROL
provides a 4-Pin CPU fan
CPU Fan Connector
(4-pin CPU_FAN1)
(see p.6, No. 2)
(Quiet Fan) connector.
If you plan to connect a
3-Pin CPU fan, please
connect it to Pin 1-3.
4 3 2 1
This motherboard
provides a 4-Pin water
GND
cooling CPU fan
FAN_VOLTAGE
CPU_F
AN_SPEED
CPU/Water Pump Fan
Connector
(4-pin CPU_FAN2/WP)
(see p.6, No. 20)
connector. If you plan
FAN_SPEED_CONTROL
to connect a 3-Pin CPU
water cooler fan, please
connect it to Pin 1-3.
English
20