Текст страницы
Removing the saw chain
To remove the saw chain, perform the following steps:
9.
Place the sprocket cover on the chain saw so that
the adjusting pin is positioned in a small hole on the
guide bar.
1.
Release the chain brake by pulling the front hand
guard.
1
2.
Turn the adjusting dial to "-" direction to release
the saw chain tension.
2
3
Fig.12
► 1. Sprocket cover 2. Guide bar 3. Hole
10.
Turn the lever clockwise fully and turn back the
lever a little to keep looseness for adjusting the chain
tension.
1
Fig.14
► 1. Adjusting dial
11.
Adjust the chain tension. Refer to the section for
adjusting saw chain tension for procedure.
3.
Pull the lever up while pressing its edge.
12.
Turn the lever clockwise until the sprocket cover is
secured then return it to the original position.
1
1
2
Fig.15
► 1. Lever
4.
Turn the lever counterclockwise until the sprocket
cover comes off.
1
2
Fig.13
► 1. Lever 2. Sprocket cover
Fig.16
► 1. Lever 2. Sprocket cover
5.
Remove the sprocket cover then remove the saw
chain and guide bar from the chain saw body.
12
ENGLISH