Текст страницы
ENGLISH (Original instructions)
SPECIFICATIONS
Model:
HP002G
Drilling capacities
Masonry
13 mm
Steel
13 mm
Wood
Auger bit: 38 mm
Self-feed bit: 38 mm
Hole saw: 51 mm
Fastening capacities
Wood screw
10 mm x 90 mm
Machine screw
M6
No load speed (RPM)
High (2)
0 - 2,200 min
-1
Low (1)
0 - 600 min
-1
Blows per minute
High (2)
0 - 33,000 min
-1
Low (1)
0 - 9,000 min
-1
Overall length
174 mm
Rated voltage
D.C. 36 V - 40 V max
Net weight
2.0 - 2.9 kg
•
Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
•
Specifications may differ from country to country.
•
The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
BL4020* / BL4025* / BL4040* / BL4050F
* : Recommended battery
Charger
DC40RA / DC40RB / DC40RC
•
Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
WARNING: Wear ear protection.
Intended use
WARNING: The noise emission during actual use
of the power tool can differ from the declared value(s)
depending on the ways in which the tool is used espe-
cially what kind of workpiece is processed.
The tool is intended for impact drilling in brick, brickwork
and masonry. It is also suitable for screw driving and
drilling without impact in wood, metal, ceramic and
plastic.
Noise
WARNING: Be sure to identify safety measures
to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the
times when the tool is switched off and when it is run-
ning idle in addition to the trigger time).
The typical A-weighted noise level determined accord-
ing to EN62841-2-1:
Sound pressure level (LpA) : 87 dB(A)
Sound power level (LWA) : 98 dB (A)
Uncertainty (K) : 3 dB(A)
Vibration
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
The vibration total value (tri-axial vector sum) deter-
mined according to EN62841-2-1:
Work mode: impact drilling into concrete
Vibration emission (ah,ID) : 9.0 m/s
2
Uncertainty (K) : 1.5 m/s
2
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Work mode: drilling into metal
Vibration emission (ah,D) : 2.5 m/s
2 or less
Uncertainty (K) : 1.5 m/s
2
4
ENGLISH