Текст страницы
INSTRUCTION MANUAL
3. To change the nozzle, please press the nozzle lock (G) and install the nozzle you
need.
4. It is recommended to install a nozzle that allows you to leave longer hair. In the
future, as necessary, you can install attachments for cutting shorter hair.
5. If you need a length exceeding 3 mm, remove the attachment and use the comb,
or adjust the length with the fingers of your free hand.
6. Set the switch (C) into the forward position and start clipping. Change the
attachments only when the device is switched off.
7. Firstly, handle a small section of hair to get used to the length of the hair being cut.
Start to clip from the occipitals and at the sides, then clip in the front moving to the
crown; all the movements should be performed against the hair growth direction.
8. Watch the speed of movement of the device when clipping. The best results can
be achieved when the device moves with its internal speed without being manually
accelerated.
9. The final treatment should be performed without an attachment by light stroking
movements along the hair growth direction starting from the crown. The blending
system is recommended to be pulled out during the final treatment and the blending
itself, if an.
10. Upon completion of clipping, set the switch (С) in the off position. If the device
was connected to the adapter, do not forget to disconnect it.
6