Текст страницы
IM022
Never insert any objects into openings in the appliance housing.
Do not put operating appliance on any surface, it may cause injury or damage.
Do not use the appliance with damaged comb, or with teeth missing from the blades as injury may occur.
NOTE: KEEP THE BLADES OILED.
The appliance should be used only with the power supply supplied with the appliance.
The instrument must be powered only by a safe, ultra-low voltage marked on the instrument.
Do not use the hair clipper when the skin is infected.
Do not use the hair clipper on animals.
If the product has been exposed to temperatures below 0ºC for some time it should be kept at
room temperature for at least 2 hours before turning it on.
The manufacturer reserves the right to introduce minor changes into the product design
without prior notice, unless such changes influence significantly the product safety,
performance, and functions.
Manufacturing date is indicated on the unit and/or on packing as well as in accompanying
documents in the following format XX.XXXX where first two figures XX is the month of
production, and following four figures XXXX is the year of production.
PREPARATION
The device is designed for cutting hair.
Before first use cutting blades of the machine should be thoroughly lubricated.
Before the first use of the appliance completely discharge and then charge the battery.
It takes about 8 hours to charge the batteries for the first time. Each subsequent charging
phase takes approx. 8 hours.
Usage time with fully charged batteries is approx. 50 minutes.
Recharge the batteries at least once in 6 months, even if the clipper is not in use.
To charge the battery, switch off the clipper and connect its power cord to mains. The indicator
lamp lights.
When the battery has charged, disconnect the clipper from mains. The clipper is ready for
operation.
OPERATION
Hold detachable comb and carefully slide arms into corresponding grooves until click.
By pushing the comb slide it to one of 24 positions to set desirable cutting length.
You may also use the clipper without the attachment.
To switch on the clipper turn the switcher to the «ON» position.
Switch off the clipper when finished, for this purpose turn the mode switch to the middle
position.
THIN-OUT FUNCTION
Allows reducing hair volume without reducing its length.
Slide the thinning cutter button to pull out the thinning cutter.
REPLACMENT COMBS
Turn off the device.
Set the length control to the "24" position (the comb is maximally extended)
Gently pull the comb up. To install the comb, carefully slide it over the cutting block so that the
clips fit into the special slots located on the sides.
REMINDERS
It is better to cut dry hair.
Comb hair carefully before cutting.
Always take off a little at a time.
For even cutting do not force the clipper. Also remember to comb the hair more frequently to
remove trimmed hair and check for uneven strands.
www.scarlett.ru
SC-HC63C54
6