Текст страницы
9. USB 3.2 Gen 1 headers
USB 3.2 Gen 1
PIN 1
The USB 3.2 Gen 1 headers allow you to connect USB 3.2 Gen 1
modules for additional USB 3.2 Gen 1 ports. The USB 3.2 Gen 1
headers provide data transfer speeds of up to 5 Gb/s.
USB3+5V
IntA_P1_SSRX-
IntA_P1_SSRX+
GND
IntA_P1_SSTX-
IntA_P1_SSTX+
GND
IntA_P1_D-
IntA_P1_D+
GND
USB3+5V
IntA_P2_SSRX-
IntA_P2_SSRX+
GND
IntA_P2_SSTX-
IntA_P2_SSTX+
GND
IntA_P2_D-
IntA_P2_D+
The USB 3.2 Gen 1 module is purchased separately.
10. USB 2.0 headers
USB 2.0
USB+5V
USB_P1-
USB_P1+
GND
NC
PIN 1
The USB 2.0 headers allow you to connect USB modules for
additional USB 2.0 ports. The USB 2.0 headers provide data
transfer speeds of up to 480 Mb/s.
PIN 1
DO NOT connect a 1394 cable to the USB connectors. Doing
so will damage the motherboard!
USB+5V
USB_P2-
USB_P2+
GND
+5V DC
Data(negative)
Data(positive)
Groud
The USB 2.0 module is purchased separately.
ADD_GEN 2
11. Addressable Gen 2 headers
PIN 1
+5V
Data
Ground
The Addressable Gen 2 headers allow you to connect individually addressable
RGB WS2812B LED strips or WS2812B based LED strips.
The Addressable Gen 2 headers support WS2812B addressable RGB LED strips (5V/Data/
Ground), with a maximum power rating of 3A (5V), and the addressable headers on this
board can handle a combined maximum of 500 LEDs.
Before you install or remove any component, ensure that the power supply is switched off
or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
•
Actual lighting and color will vary with LED strip.
•
If your LED strip does not light up, check if the addressable RGB LED strip is
connected in the correct orientation, and the 5V connector is aligned with the 5V
header on the motherboard.
•
The addressable RGB LED strip will only light up when the system is powered on.
•
The addressable RGB LED strip is purchased separately.
12. Aura RGB header
The Aura RGB header allows you to connect RGB LED strips.
The Aura RGB header supports a 5050 RGB multi-color LED strip (12V/G/R/B), with a
maximum power rating of 3A (12V).
Before you install or remove any component, ensure that the ATX power supply is switched
off or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
1-4
Chapter 1: Product Introduction