Текст страницы
11. Addressable Gen2 header
The Addressable Gen2 header allows you to connect individually addressable RGB
(ARGB) WS2812B LED strips or WS2812B based LED strips.
ADD GEN2_1
ADD GEN2_2
ADD GEN2_3
CAUTION! Before you install or remove any component, ensure that the power supply is switched
off or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
NOTE:
• The Addressable Gen2 header supports addressable RGB LED strips (5V/Data/Ground), with
a maximum power rating of 3A (5V). Additionally, the addressable header on this board can
support up to 120 LEDs per header in Gen1 mode, or a combined maximum of 500 LEDs in
Gen2 mode.
• Actual lighting and color will vary with LED strip.
• If your LED strip does not light up, check if the addressable RGB LED strip is connected in the
correct orientation, and the 5V connector is aligned with the 5V header on the motherboard.
• The addressable RGB LED strip will only light up when the system is powered on.
12. Chassis Intrusion header
The Chassis Intrusion header allows you to connect a intrusion sensor or microswitch
for the chassis intrusion detection feature. When you remove any chassis component,
the sensor or microswitch triggers and sends a high level signal and records a chassis
intrusion event.
CHASSIS
13. CPU Over Voltage jumper
The CPU Over Voltage jumper allows you to set a higher CPU voltage for a flexible
overclocking system (depending on the type of the installed CPU). Set to pins 2-3 to
increase the CPU voltage setting, or set to pins 1-2 to use the default CPU voltage
setting.
CPU_OV
26