Текст страницы
11. Addressable RGB Gen 2 header
The Addressable RGB Gen 2 header allows you to connect individually addressable
RGB (ARGB) WS2812B LED strips or WS2812B based LED strips.
ADD_GEN 2_1
ADD_GEN 2_2
ADD_GEN 2_3
CAUTION! Before you install or remove any component, ensure that the power supply is switched
off or the power cord is detached from the power supply. Failure to do so may cause severe
damage to the motherboard, peripherals, or components.
NOTE:
• The Addressable RGB Gen 2 header supports addressable RGB LED strips (5V/Data/Ground),
with a maximum power rating of 3A (5V). Additionally, the addressable header on this board
can support up to 120 LEDs per header in Gen1 mode, or a combined maximum of 500 LEDs in
Gen2 mode.
• Actual lighting and color will vary with LED strip.
• If your LED strip does not light up, check if the addressable RGB LED strip is connected in the
correct orientation, and the 5V connector is aligned with the 5V header on the motherboard.
• The addressable RGB LED strip will only light up when the system is powered on.
12. Chassis Intrusion header
The Chassis Intrusion header allows you to connect a intrusion sensor or microswitch
for the chassis intrusion detection feature. When you remove any chassis component,
the sensor or microswitch triggers and sends a high level signal and records a chassis
intrusion event.
CHASSIS
22