Текст страницы
8) M2A_CPU/M2P_SB (M.2 Socket 3 Connectors) k(Note)
The M.2 connectors on the motherboard support only M.2 PCIe SSDs.
M2A_CPU
80
110
60
42
M2P_SB
80
110
M2A_CPU
M2P_SB
•• Installing the M.2 rubber pad:
a. When using a double-sided M.2 SSD, attach the thick rubber pad to the recommended placement
area as shown below.
b. When using a single-sided M.2 SSD, first stick the thin rubber pad to the thick rubber pad, and then
attach them to the recommended placement area as shown below.
Thin Rubber Pad (Gray)
Recommended Pad Placement
Area
Thick Rubber Pad (Black)
80
Avoid contacting any chips or IC components on the motherboard when attaching the rubber pads.
Follow the steps below to correctly install an M.2 SSD in the M.2 connector.
M2A_CPU:
Step 1:Use a screwdriver to unfasten the screw on the heatsink.
Step 2:Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2
SSD. Remove the protective film from the bottom of the motherboard heatsink and then replace
the heatsink and tighten the screws.
M2P_SB:
Step:If you want to install an M.2 SSD in the 80mm hole, insert the M.2 SSD into the M.2 connector at an
angle. Press down on the front end of the M.2 SSD and make sure the M.2 SSD is secured by the
M.2 EZ-Latch Plus clip.
If you want to install an M.2 SSD in the 110mm hole that already has a motherboard heatsink
standoff, be sure to remove the EZ-Latch Plus clip first and use the provided screw to fasten the
SSD.
* Types of M.2 SSDs supported by each M.2 connector:
M.2 PCIe x4 SSD
M.2 PCIe x2 SSD
M.2 SATA SSD
M2A_CPU
a
a
r
M2P_SB
a
a
r
&
&
Please visit GIGABYTE's website for details on using M.2 EZ-Latch Plus.
Install the M.2 SSD: https://www.gigabyte.com/WebPage/920/M2-latchplus.html
Remove the M.2 SSD: https://www.gigabyte.com/WebPage/921/removeM2.html
* Motherboard heatsink design may vary by model.
k
Only for B760M AORUS ELITE.
(Note) Only for PCB rev. 1.2 or later.
- 27 -