Текст страницы
•• Installing the M.2 rubber pad (applicable only for M.2 connectors without pre-installed thermal
pads):
a. When using a double-sided M.2 SSD, attach the thick rubber pad to the recommended placement
area as shown below.
b. When using a single-sided M.2 SSD, first stick the thin rubber pad to the thick rubber pad, and then
attach them to the recommended placement area as shown below.
Thin Rubber Pad (Gray)
Recommended Pad Placement
Area
Thick Rubber Pad (Black)
80
Avoid contacting any chips or IC components on the motherboard when attaching the rubber pads.
•• M2C_CPU/M2B_CPU:
Step 1:
Turn the M.2 EZ-Latch Click clip on the M2D_SB connector clockwise and remove the motherboard
heatsink. Locate the proper mounting hole for the M.2 SSD to be installed and secure the M.2 EZ-Latch
Plus clip in the hole first.
Step 2:
Insert the M.2 SSD into the M.2 connector at an angle. Press down on the front end of the M.2 SSD
and make sure the M.2 SSD is secured by the clip.
Step 3:
Remove the protective film from the bottom of the motherboard heatsink, and finally, turn the M.2 EZ-
Latch Click clip clockwise and then install the heatsink back in place.
* Types of M.2 SSDs supported by each M.2 connector:
M.2 PCIe x4 SSD
M.2 PCIe x2 SSD
M.2 SATA SSD
M2A_CPU
a
a
r
M2C_CPU (Note)
a
a
r
M2D_SB
a
a
r
M2B_CPU (Note)
a
a
r
(Note)
Actual support may vary by CPU.
&
&
Please visit GIGABYTE's website for details on using M.2 EZ-Latch Click/M.2 EZ-Latch Plus.
M.2 SSD installation with M.2 EZ-Latch Click: https://www.gigabyte.com/WebPage/1048/M.2-EZ-Latch-Click.html
M.2 SSD installation with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/920/M2-latchplus.html
M.2 SSD removal with M.2 EZ-Latch Plus: https://www.gigabyte.com/WebPage/921/removeM2.html
* Motherboard heatsink design may vary by model.
- 26 -