Текст страницы
6
EN
• Insert the dough hooks (1) or the beaters (2) into the
corresponding installation sockets (3) until clicking. Both
attachments should be fixed in the mixer (3) openings.
Note: do not install and use the dough hook (1) and the
beater (2) at the same time.
specifications of your mains. When the unit is used in
the mains with 60 Hz frequency, it does not need any
additional settings.
• Wash the dough hooks (1) and the beaters (2) with
warm water and neutral detergent, rinse them and dry.
• Clean the mixer body (7) with a soft, slightly damp
cloth, and then wipe it dry.
USING THE MIXER
• Insert the power plug into the mains socket.
• Immerse the attachments into the bowl with ingredients,
switch the mixer on with the operation mode switch (5)
and select the desired attachment rotation speed «1, 2,
3, 4, 5».
«0» – the mixer is off.
ATTENTION! Continuous operation time of the unit
should not exceed 4 minutes. Make at least a 20
minute break between two operation cycles.
«1» - optimal speed for mixing dry and granular products,
such as flour.
Dough hooks (1)
«2» – optimal speed for mixing liquids and salad dressings.
«3» – optimal speed for making cakes or cookie dough.
• Use the hooks (1) for kneading yeasted dough, mixing
minced meat etc.
Note: insert the dough hooks (1) into the corresponding
installation openings (3).
«4» – optimal speed for beating cream, making desserts
etc.
Beaters (2)
«5» – optimal speed for beating eggs, crème, making
sugar frosting, cocktails, making potato mash etc.
If you press and hold down the button (4), the mixer will
operate at maximum rotation speed.
• Use the beaters (2) for beating cream and egg white,
making biscuit dough, puddings, cocktails, cream,
mayonnaise, puree and sauces and for mixing liquid
products.
Note: you can install the beaters (2) into any installation
openings (3).
• Make sure that the operation mode switch (5) is set
to the position «0», and the power plug is not inserted
into the mains socket.
• Do not block the ventilation openings on the mixer body
during the unit operation; this may lead to the electric
motor overheating.
• After the unit operation, set the operation mode switch
(5) to the position «0», and unplug the unit.
• Holding the attachments (1) or the whisks (2) press the
attachment release button (6).