Текст страницы
ATTENTION!
Risk of injury! Never touch the rotating attachments with your
bare hands; attachments should only be replaced after the motor
stops completely!
Risk of electric shock! Never immerse the appliance, its power
cord or plug in water or any other liquid.
Fire hazard! Never allow the appliance to contact with flammable
liquids or combustible materials!
In case of damage to the power cable or any other part of the
appliance immediately disconnect it from power supply and apply
to a service centre authorized by the Manufacturer. In case of an
unauthorized intervention into the appliance or non-observance
of the operating requirements listed in the present manual the
Manufacturer’s warranty will become void.
3.Place the ingredients into the bowl and insert the bowl into the
recess in the mixer base. Rotate the bowl counterclockwise to
engage the lock.
4.Insert the desired accessory (whisk, flat attachment or hooks)
into the connector on the inner side of the motor housing. Lock
the attachment by turning it clockwise.
5.Turn the motor housing retention button counterclockwise and
lower the motor housing until it engages with a click. Install the
splash guard (3) on the top of the bowl. The splash guard should
tightly fit on the mixer bowl to function properly. The appliance
is now ready for operation. Insert the power plug into an electric
socket. Select the speed as recommended in the attached table.
6. When you have finished mixing turn the speed selector knob
to the “0” position. Wail for the appliance to completely stop
rotating! Disconnect the appliance from power supply before
replacing the attachments or disassembling the appliance.
7. Repeat Step 2.
8.Disconnect the attachment by turning it counterclockwise.
Remove the bowl with the processed food by turning it
counterclockwise.
- APPLIANCE DESCRIPTION
- Motor housing
- Attachment connector
- Splash guard
- Bowl
- Motor housing retention button
- Speed selector knob
- Rubber feet
- Dough kneading hook attachment
- Small kneading hook
- Flat whipping attachment
- Whisk
SPEED SELECTOR
- This appliance is equipped with a speed selector. In order to
turn the appliance on and select the desired speed turn the
selector knob clockwise. An indicator on the selector will show
the selected speed. The appliance has a speed range from 0 to
6, where 0 is OFF and 6 is the maximum speed.
- The “P” mode is the boost mode. It is used to operate the
appliance at maximum speed for a short time.
- If the appliance’s motor temperature exceeds 110 °С the overheat
protection will be activated and the appliance will turn off for
some time.
- The appliance should not be operated continuously for more
than 10 minutes regardless of the selected speed. If you wish to
resume operation, turn the appliance off and on again.
- SCOPE OF SUPPLY
- Mixer, complete with bowl – 1 pc.
- Whisk – 1 pc.
- Flat whipping attachment – 1 pc.
- Dough kneading hook attachment - 1 pc.
- Small kneading hook - 1 pc.
- Splash guard – 1 pc.
- User Manual – 1 pc.
ATTENTION!
Be careful when installing the accessories. Do not touch the
rotating attachments when the appliance is operating!
4. OPERATING PROCEDURE
1. Place the appliance on a level surface.
2.Turn the motor housing retention button (5) counterclockwise;
simultaneously lift the motor housing (1) until it engages with
a click.
11. Do not use the appliance for processing hard foods, such
as frozen butter. The motor may burn out when mixing very
viscous substances.
12. Do not let children come near the operating appliance.
13. Do not use the mixer if:
- the power cord is damaged;
- the appliance is visibly damaged;
- the appliance has been dropped;
- the appliance has come in contact with moisture.
14. The appliance should not be used by physically, sensory or
mentally handicapped persons (including children) or by
persons without sufficient experience or knowledge, unless
such persons are under supervision, or have been instructed
on the use of the appliance, by the persons responsible for
their safety.
15. Do not pull or carry the appliance by its power cord.
Always disconnect the appliance from power supply before
maintenance or if the appliance does not operate properly.
16. Never disconnect the appliance from power supply by pulling
on the power cord; do not grab the power plug with wet hands.
17. If the mixes is not being used, ensure that it is disconnected
from power supply!
18. Do not use the appliance at ambient temperatures below 0
ºС and above 35 ºС.
19. Do not leave the power plug in the electric socket:
- if the appliance operates improperly (increase or unusual
noise, vibration, etc.);
- during cleaning;
- before and after each use.
20.Before disconnecting the appliance ensure that the speed
selector switch is in the “0” position. Always grab the power
plug, do not pull the plug out by the power cord. In case of
power cord damage it should be replaced, to avoid dangerous
situations, by the Manufacturer, a service centre or similar
skilled personnel.
21. Do not attempt to repair the damage or replace any parts
yourself. In case of any malfunctions please contact the
nearest service center.
22.The appliance is not designed to be powered from an external
timer or any other remote power control system.
23.Special transportation (shipment) and sale instructions: none.
24.Should You decide to transfer the appliance to another person,
please pass the present manual over along with it.
18