Текст страницы
ELECTRIC OVEN
INSTALLATION AND CONNECTION
• This product should be installed and used in strict accordance with the instructions in this
manual and with applicable state and local standards and regulations.
• The room must be well ventilated, with ventilation installed, make sure that it is well ventilated.
Consult your qualified installer if you are not sure what kind of ventilation you will need.
• Vents must have a cross-section of at least 100 cm and must be protected from accidental
blocking (protection with metal bars or nets). Make sure that there is no other furniture
behind the back of the stove.
• The air flow between the adjacent room and the room where the appliance is installed must
be free through permanent openings (which can be obtained by increasing the gap between
the door and the floor).
• The stove must be installed steadily on a flat surface away from heating appliances and
materials.
• All furniture adjacent to the gas stove must withstand a temperature of at least 85°C above
the average room temperature. The distance to the adjacent walls and kitchen furniture
should be at least 2 cm.
• It is not recommended to install the appliance near refrigerators or freezers, in order to
reduce their performance.
• The buyer is responsible for installing the appliance. Assistance provided by the manufacturer
due to incorrect installation is not included in the warranty.
ELECTRICAL CONNECTION
ATTENTION! The appliance must be connected to the main electrical network
in accordance with applicable laws and regulations.
• Make sure that the power from the main network is sufficient for the power supply system
is grounded in accordance with current regulations, and the power cable does not come
into contact with the heated elements.
• Do not use adapters, extension cords, or «tees» to connect the appliance.
• If you need to replace the power cord, make sure that it meets current standards and
meets the product specifications.
GROUNDING
• This appliance requires grounding to protect it from short circuits and electrical dissipation.
It is equipped with a grounded plug installed on the power cord. Therefore, the appliance
must be connected to an appropriate electrical outlet.
• The installation, connection and grounding of the electrical system must correspond to the
provisions of European standards, as well as applicable local regulations.
• The ground cable must not be interrupted by a switch. If your apartment does not have a
ground connection, contact a qualified electrician to install it.
ATTENTION! Before servicing the product, turn off the electrical power completely.
The manufacturer is not responsible for any direct or indirect damage caused by incorrect
installation or connection. Therefore, all installation and connection operations must be
performed by qualified personnel in accordance with applicable local and general regulations.
20
USER GUIDE