Текст страницы
- If the appliance has been turned off, You should wait for 3 to 5
- Ice Scraper- 1 pc.
- User Manual - 1 pc.
Do not use sharp objects to remove the ice as this can damage the
appliance.
Do not use chlorine chemicals or acids during the cleaning process.
5. APPLIANCE INSTALLATION
- The appliance should be transported in an upright position. Do not
minutes before turning it on again. Attempts to turn the appliance
on before the abovementioned time elapses may result in damage
to the electrical components and the compressor.
- If the freezer is overloaded with food the cooling may not be suf
ficient.
- Disconnect the freezer from power supply.
- Remove all foods from the freezer.
- Remove the drain plug located at the bottom of the freezer chamber.
- Place a suitable container for collecting the thawed water under
turn the appliance over. Tilting the appliance by more than 450 is
not allowed.
- This appliance should not be built into furniture or operated in
STORING FOODS
- Operate the freezer with the thermostat control knob set to the
niches.
- Do not install the appliance in facilities with very high temperature
the drain opening.
- Leave the freezer lid open.
- Remove the coat of ice when it starts to melt. This will reduce the
and humidity.
- A minimum space of 10 cm shall be left between the rear and side
maximum position for 2 to 3 hours before placing food into the freez
er to obtain the lowest possible temperature in the freezer chamber.
- After that time the thermostat control knob should be set to the
defrosting time
- After defrosting wipe the internal surfaces of the freezer with a
cloth damped in warm soapy water, then wipe with a dry cloth.
medium position.
- It is not recommended to open the lid of the freezer too often or to
walls of the freezer and adjacent walls to provide for proper air
circulation.
- Install the appliance in a place protected from direct sunlight and
leave it open for a prolonged time.
- The freezer chamber is designed for long-term storage of frozen
NOTE: Usually the defrosting takes several hours.
Pour slightly warm (not hot!) water on the ice so that it melts faster.
foods. Foods can be stored for up to three months.
- Different foods have different storage lives which should not be
7. CLEANING
heat sources. Direct sunlight can impact the acrylic coating and
heat sources cause increase power consumption. Very low ambient
temperatures can also cause improper operation of the appliance.
- After connecting the appliance to power supply, it should operate
- It is recommended to clean the appliance immediately after in
empty for 2 to 3 hours to cool down sufficiently before placing
food in it.
exceeded. Follow the frozen food storage guidelines when defrosting
the freezer chamber.
- Commercially packed frozen food should be stored in accordance
stallation.
- Disconnect the appliance from power supply, remove all foods and
with the manufacturer’s instructions provided on the packaging.
- Frozen foods should be placed in the freezer chamber immediately
the storage bin.
- Wipe the internal surfaces with a cloth moistened with a warm
ATTENTION! The device can be used in an unheated room at a
temperature of -15 0C.
after buying. Follow the manufacturer’s storage instructions pro
vided on the packaging.
- The storage bin is designed for storing foods of irregular shape. In
6. OPERATING PROCEDURE
SETTING THE TEMPERATURE
- The temperature in the device is regulated using the control panel
baking soda solution. Use a ratio of 2 tablespoons of baking soda
per 1 l of water.
- Wash the storage bin with a mild detergent.
- Keep the lid seals (rubber gaskets) clean for efficient operation.
- Clean the housing of the freezer with a mild detergent and warm
order to reach the other foods in the chamber the bin can be slid
aside or lifted off.
- It is not allowed to place warm or hot foods, as well as liquids in
(5), which is located in the lower right corner.
- The green indicator on the control panel indicates that the device
glass containers and carbonated beverages and liquids in bottles
and cans in the freezer.
water.
- Wipe the appliance dry with a soft cloth.
- Clean the condenser heat exchanger using a vacuum cleaner if it
is working.
- The set temperature is regulated by the thermostat knob.
- In the “Refrigerator” mode, the device operates at a temperature
is contaminated with dust or dirt.
- It is recommended to clean the freezer during defrosting. This will
from 0 to +10 ⁰C.
- In the “Freezer” mode, the device operates at temperatures from
allow to prevent the development of unpleasant odors and make
operation of the appliance more efficient.
-12 to -24 ⁰C.
DEFROSTING
For the most efficient operation and lower power consumption it is
recommended to defrost the freezer every time the thickness of the
ice coat reaches 5 to 10 mm. Choose the time for defrosting when the
stock of food in the freezer is not large.
SUSPENDING APPLIANCE OPERATION
ATTENTION!
- Pull the plug from the electric socket to disconnect the freezer
from power supply.
Do not use hot water to remove the ice as this can damage the
plastic parts.
- Remove the frozen foods from the appliance.
- Disconnect the appliance from power supply.
- Perform appliance cleaning as described above.
11